Makro Detector JeoScan 2D system Manuel d'utilisateur télécharger pdf (Page 15)

6. If there is no ground effect on the device there is

no interaction on the bar that is indicated in the

figure and “Ground Setting 100% Completed”

expression is displayed. In this case the device is

ready for exploring and you may switch to

explore mode by pressing the “ACCEPT” button.

7. In case there is ground effect on the device an

interaction is observed in the “GROUND ADJUST”

bars that are indicated in the figure. To eliminate

this effect press “-“ button for “-“ effect and

press “+” button for “+” effect. Press “-“ or “+”

buttons until this effect is eliminated and

“Ground Setting 100% Completed” expression is

displayed.

8. After pressing “+” or “-“ buttons lift the search coil 40 cm above ground and press

the “RESET” button and observe the ground effect by holding the search coil 3-5 cm

above ground, if ground effect persists try to eliminate this effect by pressing “+” or

“-“ buttons.

9. If we are not able to eliminate the ground effect decrease the sensitivity level one

step and repeat the above defined operation.

10. After the ground effect is eliminated you may press the “ACCEPT” button and switch

to Explore Mode.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Pas de commentaire

Makro Detector JeoScan 2D system Manuel d'utilisateur Page 15