Makro Detector JeoScan 2D system Manuel d'utilisateur télécharger pdf (Page 8)

ASSEMBLY AND CHARGING THE BATTERY

1. CHARGING THE BATTERY:

Remove the battery from the system box and connect to the charger. When battery is

being charged red LED will lights and when the charging is done green LED will lights. If

there is no battery attached to the charger or the attached battery is fully charged the

green LED lights. After charging, disconnect the battery from the charger and place it into

system box.

The charging period required for a fully depleted battery to be fully charged is 7 hours.

2. ASSEMBLY:

Search coil is taken off the carrying case and telescopic extension tube is inserted, piece

Nr.1 into piece Nr.2 as shown in the diagram and tighten the sleeve.

The search coil is dismounted from the extension tube when packing in the carrying case.

Dismantling is carried out as the reverse of the process described above.

CAUTION: Do not take apart the screws that connect the Connecting piece and Search

coil. Take off only the telescopic tube without damaging cable coil and suitably store in

the carrying case.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Pas de commentaire

Makro Detector JeoScan 2D system Manuel d'utilisateur Page 8