Makro Detector JeoScan 2D system Manuel d'utilisateur télécharger pdf (Page 17)

 If the target is valuable metal, there is a raise

both on the “METAL” and ”VALUABLE” that is

expressed in % depending on the magnitude

of the effect. The effect of metal can be

monitored in the graph on top of the bars.

 If the target is worthless metal there is a raise

both on the “METAL” “IRON” that is expressed

in % depending on the magnitude of the

effect.

 When an alarm is received from the device over any point; the device is taken away

from the target and reset in an area where no signal is received and the search coil

is passed over the same target again. If there is increase in the “CAVITY” bar, our

target is a cavity. If there is increase in the “METAL” and “VALUABLE” or “IRON” bar,

our target is a metal. If required the “RESET” button is pressed and search coil is

passed over the target once more. This last operation is done to be sure about the

result.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Pas de commentaire

Makro Detector JeoScan 2D system Manuel d'utilisateur Page 17