Makro Detector JeoScan 2D system Manuel d'utilisateur télécharger pdf (Page 21)

 Enter the “Width” value by using “+” and “-“

keys. Press the “ACCEPT” button after entering

the width value and convert the frame into

yellow.

 To enter the determined length dimension

place the yellow frame on “Length” by using

“+” and “-“ keys. Press the “ACCEPT” button to

convert the yellow frame to green.

 Enter the “Length” value by using “+” and “-“

keys. Press the “ACCEPT” button after entering

the length value.

 Press the “SCAN “ button after this operation

and pass over the target again and release the

“SCAN” button

 After this operation the device presents an

“Analysis Report” that indicates whether the

target is METAL or CAVITY, entered dimension

values and environmental effects.

 Press the “ACCEPT” button to leave this

report.

 Switched back to Depth mode and switched to

explore mode by pressing the “DEPTH” button.

1 2 ... 16 17 18 19 20 21 22 23 24

Pas de commentaire

Makro Detector JeoScan 2D system Manuel d'utilisateur Page 21