Makro Detector JeoScan 2D system Manuel d'utilisateur télécharger pdf (Page 19)

9- Target is a cavity and deeper

underground;

10- Target is a metal inside of a cavity;

11- If the oscilloscope line draws a

straight line close to center line, it

points that the ground is a high-mineral

soil. So, the ground balance needed to

be recalibrated.

If the signal line increases very sharp and decreases with same velocity there is no need

to calculate depth. Because, this shows that the target is very close the surface.

Oscilloscope never draws a straight line while it receives signals from true target, it

always draws sinuous lines. Oscilloscope line is closer the center line when the target is

deep and line is away from the center line when the target is close.

Ferrous Metal Elimination Function:

The device can enable to filter the worthless metals

by the device and warn the operator if desired. For

this operation “IRON” mode should be off. To

switch off this mode press “SETUP” button when in

explore or ground modes. Select the “IRON” mode

by pressing the “+” key. After selecting this mode

press the “ACCEPT” button. Place the frame that

turns from yellow to into green on “OFF” and press

the “ACCEPT” button again. After this operation

press “SETUP” button to switch to the previous

mode. Following this step the device will filter worthless metals. To be able to detect

worthless metals again this mode should be switched back to “ON” mode by repeating

above mentioned operation.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Pas de commentaire

Makro Detector JeoScan 2D system Manuel d'utilisateur Page 19