Makro Detector JeoScan 2D system Manuel d'utilisateur télécharger pdf (Page 13)

WHAT IS GROUND SETTING AND

HOW IT IS DONE?

In our country land formation and soil composition vary in relation to regions. In some

regions the composition may vary frequently (Sand, lime, red earth with dense mineral

content, rocky formation, etc.).

These variations in soil composition mislead the detector and cause perception as metal

or cavity. Therefore first we have to launch the soil characteristics of the region to the

detector’s system. Launching these data will block all misleading effects that may come

up from the ground; these will be perceived as misleading signals from the ground, and

thus eliminated.

Ground setting is one of the most important provisions of exploration. Therefore the

operator should be a keen observer and should be able to detect variations in the

ground. He has to observe soil compositions continuously to be able to make ground

adjustment again in case misleading signals the device will perceive results from

variations in soil composition.

Ground setting is made for the device to recognize the soil and not to be affected by it.

Thus the device is not affected from metal or cavity reflections of varying soil

compositions. If ground setting is not properly done it will cause loss of depth and

minerals to be evaluated as metals or cavities. Therefore ground settings should be

made as correctly as possible.

Considering the general condition of land formation in our country, a ground setting

system is established that will eliminate ground effect on the device.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Pas de commentaire

Makro Detector JeoScan 2D system Manuel d'utilisateur Page 13